Safety Instructions
SP10 Pro is a powerful flashlight. Never point the beam directly at a person, animal or
moving vehicles. Doing so could cause retinal damage. Please do not allow children to play
with it. Strobe mode may cause seizure in persons with photosensitive epilepsy.
Operating the flashlight for a long time in Turbo or High mode will warm it up. This is normal.
SP10 Pro is intended to be used with an AA battery or a premium 14500 rechargeable battery.
When installing the battery, make sure the anode (+) side always faces towards the head/LEDs.
Unscrew the tailcap half a turn to avoid unwanted activation during transport. It also
prevents the battery from draining while the flashlight is in standby.
Avoid hitting or dropping the flashlight.
Troubleshooting and Maintenance
Disassembling the sealed head can damage the flashlight and voids the warranty.
Sofirn Ltd. recommends using high-quality brand batteries. Damage by battery leakage voids
the warranty.
Remove the battery if the flashlight will not be used for an extended period of time.
To prevent self-discharge or accidental activation during storage or transportation, unscrew the
tailcap by half a turn or remove the battery.
Every 6 months threads should be wiped with a clean cloth followed by a thin layer of silicone
grease.
To maintain a proper level of waterproofness, replace worn-out o-rings with an approved spare.
Troubleshooting: Clean battery contacts regularly as dirty contacts may impair the performance
of the flashlight. If you experience problems (flicker, shine intermittently or failure turn on) the
following root causes and solutions should be tried:
Reason A: The battery needs a replacement.
To Next Page
Loading...
