Ramp configuration
Both the SMOOTH RAMP and the STEPPED RAMP are configurable. The user can set the lowest
level, the highest level, and (STEPPED only) the number of steps.
While the light is ON in one of the ramping modes, click 4 times to enter RAMP CONFIGURATION for
the current ramp.
For SMOOTH RAMPING, there are 2 menu options:
1. Floor (default level = 1/150)
2. Ceiling (default = 120/150)
For the STEPPED RAMPING, there are 3 menu options:
1. Floor (default level = 20/150)
2. Ceiling (default = 120/150)
3. Number of steps (default = 7)
To configure the floor level, click the button equal to the number of ramp levels (out of 150) at which
the floor should be. To set the lowest possible level, click once. (MOON)
To configure the ceiling level, each click goes one level lower. So 1 click sets the highest possible level,
2 clicks is the 2nd-highest, 3 clicks is the 3rd-highest level, etc. Ceiling clicks: 151 – ( level you want
) = Clicks To set the default of 120/150, click 31 times.
When configuring the number of steps, the value can be anything from 2 to 150.
If you want to change the floor and ceiling to the lowest and highest values, you click once for each.
Defaults settings SP36
SP36
SMOOTH STEPPED
Level
ca.
lm
Level
ca.
lm
max
FET
150 5600 150 5600
Default
Ceiling
120 2800 120 2800
single
7135
max
65 125 65 125
Default
Floor
1 Moon 20 4
Default
Steps
– 7
Thermal configuration
Look at a thermometer to check the current room temperature. Let us assume it says 21 Celsius.
Turn the light off and wait for its temperature to settle to room temperature.
Go to TempCheck (from OFF: “Click Click Click”. Ascend with double-clicks three times)
When you are in TempCheck, then click 4 times to enter thermal config mode, and calibrate the
sensor.
To Next Page
Loading...
