about 1-2 inches of water. Stop filling, add one tablespoon of chlorine
from your water treatment kit. Hint: Now is a good time to get out any
remaining wrinkles. For those who have a 300+ with a seat, you will need
to stop filling again when the water is 1-2 inches above the seat to smooth
any wrinkles.
__11. To smooth out wrinkles, press on the wrinkle and move the materi-
al outward. Pulling on the liner and tucking it into the corner edge also
helps to elimlinate the wrinkles. When all wrinkles are removed, continue
to fill until water level is about 2 inches above the highest jet.
__12. As the tub fills, check your three hose clamp connections for leaks.
Hint: If you see a leak, don’t panic. Turn off water and tighten the clamps
until they stop leaking.
__13. Plug the unit into a grounded, three-hole 110-120 volt outlet with
isolated power supply of 15 amps. The light on your plug will light up, and
in 10 seconds, your pump will start.
__14. Get the foam insulation piece from the accessory package and
place it between the motor unit and the tub. Now cover the foam with the
vinyl cover and Velcro at the bottom.
__15. Open your water treatment kit and follow the recommendations to
treat and test your water.
__16. Congratulations! Your Softub is now ready to heat to your desired
temperature. Push the plus (+) button to make the water hotter or the
minus (-) button to lower the water temperature. Set the temperature
where you will be most comfortable.
Hint: The tub will heat faster if you turn off the air control (fewer bubbles)
- it’s the handle on top of the motor unit, and cover the tub with the lid.
The water temperature will rise at about 1 - 2 degrees F per hour, depend-
ing on the model. The Softub will turn off after the water reaches the set
temperature. See TEMPERATURE SETTING, page 12, to adjust temper-
ature.
It is the responsibility of the tub owner to make sure the above instal-
lation conditions are met as well as to follow the Safety and Warning
Instructions. Softub, Inc. is not responsible for any damage, which
may result from water spillage, excessive humidity, or structural
loading. Please take all precautions necessary to ensure years of
joyful use of your Softub.
11
To Next Page
