__1. Your hot tub comes with safety straps, be sure to put them under the
tub prior to filling, laying them in an “x” fashion and setting the hot tub on
top of the straps. Make sure the straps are straight and the hot tub is
placed on a level surface.
__2. Put the lid on the hot tub and test the straps to make sure that you
are able to fasten them properly.
__3. Set the motor unit beside the Softub on the same level surface.
Align the hoses from the motor unit with the fitting on the tub. DO NOT
PLUG IN THE UNIT.
__4. Take the three hose clamps (found in the accessory bag that came
in the tub) and place them over the hoses on the motor unit.
__5. Push the motor unit towards the tub while guiding the hoses over the
tub fittings. Hint: start with the air hose (smallest) first. Continue pushing
until the end of the hose covers ¼ inch of the black tub fitting.
__6. Slide the clamps towards the tub. Allow about ¾ inch of hose to
show. Tighten the clamps. Hint: Make sure not to over tighten—just
make them snug. You can always tighten more if the hose begins to leak
while filling.
__7. With the motor now connected, make sure the tub is placed where
you want it to be. Remember to leave room for a deck surround or steps.
__8. If your filter is not installed on one of the suction covers, soak the fil-
ter connector in lukewarm water for two minutes (this makes the filter easy
to install). After soaking in warm water, snap the filter over the fitting in the
tub. (See filter information, page 17)
__9. Turn on the hose and allow the water to run into the grass or a gar-
den for a few minutes. This will rinse the inside of the hose of any bacte-
ria or algae (Both grow in stagnant water left in the hose when not being
used and could introduce contaminants to the tub). CAUTION: Make
sure not to fill the Softub with soft water.
__10. Make sure any wrinkles in the liner are smoothed out and add
Set-Up Checklist
10
To Next Page
