Solar Electronics 9354-2 - 5.3 Open Circuit Voltage

Solar Electronics Company
10 MHz Damped
sinusoidal
into 9142-1N
% of Amplitude to
active
I max 70 %
I max 10 amps = 500 volts 50 ohm coaxial
cable ~ 6 ft
30 MHz
into 9142-1N
% of Amplitude to
active
I max 70 %
I max 10 amps = 500 volts 93 ohm coaxial
cable ~ 6 ft
100 MHz
into 9142-1N
% of Amplitude to
active
I max 60 %
I max 3 amps = 150 volts 50 ohm coaxial
cable ~12 ft
5.3 Open Circuit Voltage
Additional Equipment used
Type 9454-1 High voltage Attenuator 600/50. The 600 ohm input of the 9454-1 attenuator connected to
the Model 9354-1 is ideal for simulating open circuit testing.
BNC to banana adaptor.
1 MHz
into Type 9454-1
attenuator
Amplitude to achieve
open circuit voltage ~
87 %
3200 volts
10 MHz
into Type 9454-1
attenuator
Amplitude to achieve
open circuit voltage ~
87 %
3200 volts
6.4 μS
into Type 9454-1
attenuator
Amplitude to achieve
open circuit voltage ~
87 %
1600 volts
70 μS
into Type 9454-1
attenuator
Amplitude to achieve
open circuit voltage ~
87 %
1600 volts
500 μS
into Type 9454-1
attenuator
Amplitude to achieve
open circuit voltage ~
87 %
1600 volts
IMPORTANT NOTE
LIMITATIONS of newer Digital Oscilloscope: DIGITAL Oscilloscopes that have a maximum 1 volt
per division with a 50 ohm input cannot view the 3200 volt open circuit damped sinusoidal, or the 1600