EV ChargerWeb interface
Configuration manual V1.00
20
© SolarEdge Technologies
Operating Mode
Here you can determine whether the charging station is operated as a single
charging station or as a master charging station in a charging network.
The number of clients must be entered for a charging network. In addition,
all attached client charging stations must be entered with their respective se-
rial numbers. Otherwise, the client charging station will not be recognized by
the master charging station in the network. The serial number is printed on
the rating plate of the client charging station.
Both the master charging station and all attached client charging stations
can be enabled ("available") or disabled ("out of service") individually. If the
charging station is disabled during a charging process, the charging process
will be stopped. When the charging station is disabled, the LED bar slowly
flashes orange and the display shows that the charging station is out of op-
eration.
Device
The basic settings for the charging station are configured here:
Managing the authorization function (see 5.1.1 Authorization modes); syn-
chronizing the time of the charging station with the time of the browser (the
charging station restarts after a time synchronization); activating and deacti-
vating the USB stick functions; deleting the event log (log file).
Network Connection
The network communication can be selected and configured here.
Certificates
For an encrypted connection, certificates can be imported in *.pfx format.
The connection to the web interface, OCPP backend and charging station
can be encrypted. The following certificates are available:
OCPP certificates
Certificate Purpose
Charge point certificate Encrypted connection to the OCPP server
Central system root certificate
Certificate for logging in to the charging sta-
tion at the OCPP backend (OCPP 1.6 JSON
Security)
OCPP server certificate Encrypted connection to the charging station
Manufacturer root certificate
Check of the signature for firmware updates
(OCPP 1.6 JSON Security)
WLAN Access Point
The WLAN access point can be configured here and enabled or disabled as
required.
To Next Page
Loading...
