18
19
4.3 Tools
These tools are required to install the T-BAT system.
4.4 Preparation
4.4.1 Check for Transport Damage
4.2 Safety Gear
Installation and maintenance personnel must operate according to applicable
federal, state, and local regulations as well as industry standards regarding product
installation. Personnel must wear safety gear as indicated below in order to avoid
short circuit and personal injury.
Insulated Gloves
Safety Goggles
Safety Shoes
Anti-dust respirator
4.4.2 Unpacking
Unpack the battery package by removing the packing tape. Ensure the battery
modules and relevant items are complete. Refer to the packaging items in section
"4.4.3 Accessories" and check the packing lists carefully. If any accessory is
missing, immediately contact our company or your distributor directly.
WARNING!
Strictly follow the installation steps. Our company will not be
responsible for any injuries or loss incurred by incorrect assembly and
operation.
NOTE!
When installing the battery for the first time, the manufacturing date between
battery modules should not exceed 3 months.
4. Preparation before Installation
4. Preparation before Installation
Torque Screw Driver Phillips-screw Driver
Hexagon Wrench
Pencil or Marker
Spirit Level
Torque Wrench
Drill
Phillips-head Screw Driver
Ensure the battery is intact during and after transportation. If there are visible
damages such as cracks, contact your dealer immediately.
CAUTION!
According to regional regulations, several people may be required for
moving the equipment.
To Next Page
Loading...
Need help?
General
