1 Note on this Manual
1.1 Scope of Validity
1.2 Target Group
1.3 Symbols
1.Notes on this Manual
Note: There are 2 models of T-BAT system, which includes BMS, and battery
module(s). Refer to section 3.3 T-BAT-SYS-HV Configuration List on Page 13 for
detailed models.
5 EQUIPMENT INSTALLATION....................................................................................22
5.1 INSTALLATION ENVIRONMENT REQUIREMENTS ..................................22
5.2 INSTALLATION MODE .......................................................................................22
5.2.1 RACK INSTALLATION ........................................................................22
5.2.2 CABINET INSTALLATION .................................................................32
6 COMMISSIONING.......................................................................................................44
6.1 DIP SWITCH..........................................................................................................44
6.2 COMMISSIONING...............................................................................................45
6.3 STATUS INDICATORS.........................................................................................48
6.3.1 BMS (TBMS-MCR0800) ...................................................................48
7 TROUBLESHOOTING ................................................................................................49
7.1 TROUBLESHOOTING ........................................................................................49
8 DECOMMISSIONING .................................................................................................53
8.1 DISMANTLING THE BATTERY.........................................................................53
8.2 PACKING.................................................................................................................53
9 MAINTENANCE ............................................................................................................54
10 DISCLAIMER..................................................................................................................55
* WARRANTY REGISTRATION FORM
T-BAT-SYS-HV-R2.5 Module
T-BAT-SYS-HV-R2.5/T-BAT-SYS-HV-R3.6 BMS
TP-HR25
TBMS-MCR0800
T-BAT-SYS-HV-R3.6 Module
TP-HR36
This manual is an integral part of the T-BAT Series. It describes the assembly,
installation, commissioning, maintenance and failure of the product. Read it carefully
before operation.
This manual is for qualified electricians. The tasks described in this manual may only
be performed by qualified electricians.
The following types of safety instructions appear in this document and are
described below:
DANGER!
“DANGER” indicates a hazardous situation which, if not avoided, will
result in serious injury or death.
WARNING!
“WARNING” indicates a hazardous situation which, if not avoided, could
result in serious injury or death.
CAUTION!
“CAUTION” indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTE!
“NOTE” provides tips that are valuable for the optimal operation of your
product.