SolaX Power ZDNY Series - Page 19

Yield
●
Yield interface display the generated power with histogram.
-User can get into the interface by select the”Yield” with cursor on the menu
interface and press”OK” to conrm.
-The X-axis can be switched with Day or Hour by press left and right button.
-The Y-axis display the total generated power.
-Move the cursor to “Back”and press”OK” to get back to the menu interface.
Yield
Back
E 200KWH
t/day
Error log
●
Error log interface displays the error information happened with the inverter.
It can record at most 5 items.
-Enter the error log interface by select the”Error Log” with cursor on the menu
interface and press “OK” to conrm.
-It can display 3 items,press up and down button to see more error items.
-Move the cursor to “Back”and press”OK” to get back to the menu interface.
Error Log
Back
1:2012-02-24 13:23:24
Grid Lost Fault
2:2012-03-24 14:14:24
SW_FANIFault
3:2012-04-24 13:11:24
SW OCP DCI
Setting
●
User can get the safety,time,password and connection etc. with this function.
-Enter the “Setting”by select the “Setting” with cursor on the menu interface and
press “Ok”to conrm.
-The pass word interface will appears for the user to enter the password.
-Enter the password,conrm with”OK”.
Note:The default password is “1234" for the rst time to enter.
Password
Back OK
0000
If the password is correct it will jump into the setting interface or it will return
back to the menu interface.
Comm Address
New Password
Power Factor
Reset
Setting RTC
Connection
Grid Setting
Safety
Setting
Back
A)Comm Address
-The user can setting the comm address here.
-Press up or down to increase or decrease the value.
-Press OK to conrm.
Comm Address
Back OK
000
B)Setting RTC
Setting RTC is used to set the current system time.
-Enter the “Setting RTC” by select the “Setting RTC” with cursor on the setting
interface and press “OK” to conrm.
-Alternate the cursor by press function button,when the cursor is on the item
35
34
6 Operation Method 6 Operation Method