24
USING HEART RATE
TRANSMITTER
(OPTIONAL)
How to wear your wireless chest strap transmitter:
1. Attach the transmitter to the elastic strap using the locking parts.
2. Adjust the strap as tightly as possible as long as the strap is not too tight to
remain comfortable.
3. Position the transmitter with the SOLE logo centered in the middle of your
body facing away from your chest (some people must position the
transmitter slightly left of center). Attach the end of the elastic strap by
inserting the round end and, using the locking parts, secure the transmitter
and strap around your chest.
4. Position the transmitter immediately below the pectoral muscles.
5. Sweat is the best conductor to measure very minute heartbeat electrical signals.
However, plain water can also be used to pre-wet the electrodes (2 ribbed oval areas on the reverse
side of the belt and both sides of the transmitter). It’s also recommended that you wear the
transmitter strap a few minutes before your workout. Some users, because of body chemistry, have a
more difficult time achieving a strong, steady signal at the beginning. After “warming up”, this
problem lessens. As noted, wearing clothing over the transmitter/strap doesn’t affect performance.
6. Your workout must be within range - distance between transmitter/receiver – to achieve a strong
steady signal. The length of range may vary somewhat but generally stay close enough to the console
to maintain good, strong, reliable readings. Wearing the transmitter immediately against bare skin
assures you of proper operation. If you wish, you may wear the transmitter over a shirt. To do so,
moisten the areas of the shirt that the electrodes will rest upon.
Note: The transmitter is automatically activated when it detects activity from the user’s heart. Additionally, it
automatically deactivates when it does not receive any activity. Although the transmitter is water resistant, moisture can
have the effect of creating false signals, so you should take precautions to completely dry the transmitter after use to
prolong battery life (estimated transmitter battery life is 2500 hours). The replacement battery is Panasonic CR2032.
ERRATIC OPERATION
Caution! Do not use this elliptical for Heart Rate unless a steady, solid Actual Heart Rate value is being
displayed. High, wild, random numbers being displayed indicate a problem.
Areas to look for interference which may cause erratic heart rate:
1. Microwave ovens, TV’s, small appliances, etc.
2. Fluorescent lights.
3. Some household security systems.
4. Perimeter fence for a pet.
5. Some people have problems with the transmitter picking up a signal from their skin. If you have problems,
try wearing the transmitter upside down. Normally the transmitter will be oriented so the SOLE logo is
right side up.
6. The antenna that picks up your heart rate is very sensitive. If there is an outside noise source, turning
the whole machine 90 degrees may de-tune the interference.
7. Another Individual wearing a transmitter within 3’ of your machine’s console.
If you continue to experience problems, contact your dealer.
To Next Page
Loading...
