Sole indoor Cycling Console Battery installation:
1. Remove the battery cover from the back of the computer.
2. Insert 2 AAA batteries into the battery compartment and reinstall the battery cover.
3. When Battery working voltage is too low, The "Low battery" indicator will show up on the
console display indicating it is time to change the batteries.
Speed Sensor Transmitter Battery Installation
1. Remove the battery cover from the transmitter.
2. Install 2 AAA batteries in the battery compartment and reinstall the battery cover.
3. When new batteries are installed in the transmitter or console you must perform the
synchronizing procedure below for the console to work properly
Synchronizing the transmitter to the console:
After installing the batteries, and before attaching the console and transmitter to the bike, you
must synchronize the two so they can 'talk'to each other.
1. Press and hold the two keys on the front of the console for about 3 seconds until the
display shows ID - -
2. Now press and hold the blue button on the transmitter for 3 seconds and release.The
console display should show ID O.NOTE: You must press the blue button within 10 seconds
after the console is showing ID - - otherwise the console will show: ID ER. If the console
shows this error then restart the procedure again.
3. It may be necessary to remove and re-install the batteries in both the
console and transmitter if you continue to receive an error.
Console installation:
1. Install the mounting clamp (2) to the back of the console (1) with the clamp mounting
screw (3).
2. Install and slightly tighten the thumb screw (4) then adjust the console angle for optimal
visibility. Once the console is adjusted, continue to tighten the screw until it issecurely
attached to the handle bar.
Transmitter Installation:
• Make sure to route the speed sensor wire behind the frame member. Plug the sensor wire
into the transmitter as shown below
• Install the transmitter, at the angle shown below, onto the preqnstalled Velcro strip located
on the back of the chain cover. Make sure the sensor wire connection is at the top left
when mounting the transmitter.
• Make sure the sensor wire is routed away from the spinning flywheel
7 SBTO0 INDOOR CYCLE
To Next Page
Loading...
