SOLINTEG INTEG M MHT-10K-40 - Reactive Power

68
User Manual
MHT-4~20K series
※ 7.5 Reactive Power

This mode can be enabled via configuration software. It is enabled by default in some



Mode Descriptions
 


Qt 
Cos
φ
 
 
s

7.5.2 “PF” Mode

power. The PF ranges from 0.8 leading to 0.8 lagging.


Figure 7-1 Capabilities
P
P
D
P
D
P
D
Absorption of reactive energy
xcited
Provision of reactive energy
ver-excite
Requirement
Design freedom area
in some countries


max

max