What to do if SOLIS S5-GR1P10K Inverter displays DC-INTF OV-DCA-I error?
If your SOLIS Inverter displays a DC-INTF OV-DCA-I error, try restarting the inverter. If that doesn't work, identify and remove the string to the fault MPPT. As a last resort, consider changing the power board.
What to do if SOLIS Inverter LCD shows initializing all the time?
If the LCD screen of your SOLIS Inverter continuously displays 'initializing', check if the connectors on the main board or power board are securely fixed. Also, check if the DSP connector to the power board is properly connected.
What to do if SOLIS S5-GR1P10K Inverter displays OV-BUS error?
If your SOLIS Inverter displays an OV-BUS error, check the inverter inductor connection and the driver connection.
What to do if my SOLIS S5-GR1P10K screen is OFF with DC applied?
If your SOLIS Inverter screen is off while DC is applied, do not turn off the DC switches as it can damage the inverter. Wait for the solar irradiance to reduce and confirm the string current is less than 0.5A with a clip-on ammeter before turning off the DC switches. Note that damages due to wrong operations are not covered in the device warranty.
What to do for Arcing protection on SOLIS S5-GR1P10K?
If the SOLIS Inverter is showing an arcing protection issue, check the inverter connection for any arcs and then restart the inverter.
Explains safety symbols and outlines essential safety guidelines for operation.
Specifies installation/operational guidelines and product disposal instructions.
Covers procedures for connecting the PV input and AC output.
Step-by-step guides for safely starting and stopping the inverter.
Introduction to advanced settings for technicians, including standard selection.
Internal EPM settings and selecting the operational mode for power management.
Calibrating power parameters and overview of the AFCI function.
Steps to enable AFCI and how the inverter handles detected arc faults.
To Next Page
General
