67EV1
35
Onboard Serial
Port 1 / Port2
Select an address and corresponding interrupt for the
first and second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
IRQ3, Disabled, Auto.
UART Mode Select This item allows you to select UART mode.
The choice: Enabled, Disabled.
UART2 Duplex Mode This item allows you to select the IR half / full duplex
function.
The choice: Half, Full.
RxD, TxD Active This item allows you to determine the active of RxD,
TxD.
The choice: “Hi, Hi”, “Hi, Lo”, “Lo, Lo”, “Lo, Hi”.
IR Transmission delay This item allows you to enable / disable IR transmis-
sion delay.
The choice: Enabled, Disabled.
Onboard Parallel Port This item allows you to determine onboard parallel
port controller I/O address setting.
The choice: 378H/IRQ7, 278H/IRQ5, 3BC/IRQ7,
Disabled.
Parallel Port Mode Select an operating mode for the onboard parallel
(printer) port. Select Normal, Compatible, or SPP
unless you are certain your hardware and software
both support one of the other available modes.
The choice: SPP, EPP, ECP, ECP + EPP.
ECP Mode Use DMA Select a DMA channel for the parallel port for use
during ECP mode.
The choice: 3, 1.
EPP Mode Select Select EPP port type 1.7 or 1.9
The choice: EPP1.7, 1.9.
To Next Page
Loading...
