67EV1
37
3-9 SUPERVISOR / USER PASSWORD
• These two options allow you to set your sysem passwords. Normally, the
supervisor has a higher ability to change the CMOS setup option than the
user. The way to set up the passwords for both Supervisor and User are
as follows:
1. Choose “Change Password” in the Main Menu and press <Enter>. The
following message appears:
“Enter Password : “
2. The first time you run this option, enter your password up to 8 characters
and press <Enter>. The screen does not display the enterd characters.
3. After you enter the password, the following message appears prompting
you to confirm the password:
“Confirm Password : “
4. Enter the same password “exactly” as you just typed again to confirm the
password and press <Enter>.
5. Move the cursor to Save & Exit Setup to save the password.
6. If you need to delete the password ou entered before, choose the Super-
visor Password and press <Enter>. It will delete the password that you
had before.
7. Move the cursor to Save & Exit Setup to save the option you did, other-
wise the old password will still be there the next time you turn your system
on.
8. Press <Enter> to exit to the Main Menu.
NOTE: If you forget or lose the password, the only way to access
the system is to clear the CMOS RAM. All setup informa-
tions will be lost and you need to run the BIOS setup pro-
gram again.
To Next Page
Loading...
