4.7 ENGINE FAILURE TRAINING
1. Navigate - start above landing area at 1500ft AGL
2. Throttle - reduce to idle
3. Speed - V
BG
65 KIAS
4. Flaps - T/O setting
5. Oil Temperature - check, apply power if required (see note
below)
6. Align for final approach - adjust landing pattern in order to be at an
adequate height above the landing spot during
approach
7. Flaps - as required
8. Speed - approach between 55 – 60 KIAS (as required to
maintain desired glideslope and depending on
flaps setting)
9. Gently touch-down on main wheels at 55 KIAS
10. Nose wheel - maintain above ground using elevator control
until airspeed below 50 KIAS, then gently lower
to ground
11. Apply brakes - as required
NOTE
During descent, do not allow Oil Temperature to decrease below 50°C. If
necessary, apply power accordingly.
To Next Page
