sonaca aircraft S201 - Page 80

S201 AFM
3 - EMERGENCY PROCEDURES
3.4 - SMOKE AND FIRE
27/06/2019
SONAIR-S2-D-MAN-006
Page : 3-18
Rev. : A
5. Check Circuit Breaker panel - look for pulled breakers
6. If the source of the electrical fire can be determined and electrical power can
be removed from that system by isolating / switching the system off, do so :
7. All switches - off
8. ALT 2 switch - on
9. All switches - restore one by one, waiting 10 seconds
minimum between each. Switch off bad circuit if smoke appears again.
10. BATT switch - on
11. Land as soon as practicable (with canopy closed)
WARNING
Never attempt to push an automatic pulled breaker after electrical fire !
CAUTION
If conditions and location allows, prefer landing as soon as possible instead
of fire source identification
NOTE
Battery power is restored at last to protect this source for final approach and
landing