3.3 Inserting the battery in the remote control
1.
Open the battery compartment cover on the back of the remote control by
turning it anticlockwise using a small coin.
2.
Insert the supplied batteries (CR2032, 3 V) with the label (+) side up.
3.
Replace and close the battery compartment cover by turning the cover
clockwise using a small coin.
Do not block the infra-red sensor on the ELITE and the infra-red
transmitter on the remote control during use.
3.4 Using the antennas
1.
Screw the rod antenna located on the back of ELITE to the FM/DAB antenna
connector.
2.
If you are using the rod antenna, pull the rods of the antenna apart and
align the antenna so that you have the best possible reception.
For even better reception, connect ELITE to a suitable house antenna.
© sonoro audio GmbH 2019 67
To Next Page
Loading...
