114
5-4 Playback
Chapter 5 Recording/Playback
Mode2: Search for zero-cross points in the same way as
Mode1, but connect zero-cross points only when low-
level samples are detected around the zero-cross
points.
Mode3: At a regular interval corresponding to the
playback speed, connect the audio data before and
after the processing target with a cross fade.
OFF: Output audio data by performing rate conversion
processing. This changes the frequency
characteristics and pitch according to the specified
program play speed.
Cross fade processing may be performed if zero-cross
points cannot be detected in Mode1 or Mode2 processing.
Note
To Next Page
Loading...
