Sony BDP - S1E - Speaker Configuration and Setup; Audio Output Mode Selection; Speaker Setup Adjustments

51
Changing the Initial Settings
Speakers
The following items are necessary when using the 5.1CH
OUTPUT jacks.
The default settings are underlined.
Audio Output Mode 2 Channel
– Select this when connecting to an AV amplifier (receiver) using the AUDIO OUT (L/
R) jacks.
5.1 Channel
– Select this when connecting to an AV amplifier (receiver) using the 5.1CH OUTPUT
jacks.
– For analog connection.
Speaker Setup Next Screen
1 Select the speaker setting that needs adjusting by pressing M/m.
• “C” (centre speaker): “Yes” or “No”
• “Ls/Rs” (left surround speaker/right surround speaker): “Yes
” or “No”
• “L/R” (left front speaker/right front speaker): “Large
” or “Small”
2 Adjust the setting by pressing </,.
• For “C” and “Ls/Rs,” select whether the speakers are included in your system.
• For “L/R,” select the size. This setting is disabled if either of “C” or “Ls/Rs” is set
to “No.”
3 Press ENTER to save the adjustments.
– This setting affects the output from the
5.1CH OUTPUT jacks.