1-22
MVS-8000 System
SYSTEM SETUP
1-3. System Description
n
The DCU-8000 has a built-in cooling system consisting of a fan mounted on the both sides of the frame,
and an air filter on the rear of the front panel. Cooling air is drawn in at the front side of the frame,
through the filter, boards, and modules, and then expelled out the both sides of the frame at the fan unit.
If dust is accumulated at the intake of the fan or the cables doesn't keep off over 10 cm from the fans, air
is prevented from flowing smoothly that result in rise of temperature inside the machine. It may result in
adverse effects on performance and life of the machine if used in such an environment.
DCU-8000 has front and rear boards. It consists of 6 slots for standard/option boards.
n
The DCU-8000 is shown below with the front panel removed. The front panel must remain in place and
closed during normal system operation to keep maximum cooling efficiency.
Power, control, and video connections are at the rear of DCU-8000. The illustration below shows a full
loaded rear board. Some of the modules shown below are optional and may not be included in your
system configuration.
Fans
2
6
Slots on
the front side
TALLY/GPI IN 1 to 34,
35 to 68, 69 to 102 connectors
TALLY/GPI OUT 1 to 18,
19 to 36, 37 to 54 connectors
PERIPH connector
SERIAL TALLY 1 and 2 connectors
REMOTE 1 to 6 connectors
AC IN A and B connectors
REF IN connectors
terminal
DCU-8000
Device Control Unit
DCU-8000
Device Control Unit
DCU-8000
Device Control Unit
To Next Page
Loading...
