1-23
MVS-8000 System
SYSTEM SETUP
1-3. System Description
DCU-8000 options
The following lists the plug-in boards that may be purchased as options.
DCU-8000 option configuration
Front Side
Option name Board name Slot No. Descriptions
MKS-8701 RC-90 2 to 6 Tally/GPI output Board
MKS-8702 IF-848 2 to 6 Serial Interface Board
Rear side
Option name Board name Slot No. Descriptions
MKS-8701 CN-2195 _ Tally/GPI output Board
Install the board into the slot in the real that
corresponds to a RC-90 board that is inserted
in the slot in the front.
MKS-8702 CN-2194 _ Serial Interface Board
Install the board into the slot in the real that
corresponds to a IF-848 board that is inserted
in the slot in the front.
Power supply unit
The DCU-8000 Power Supply Units is supplied with DCU-8000 processor.
A power supply units is required to run the system. An Optional second unit is added to provide redun-
dant power. With second unit mounted, one unit can fail without causing system failure.
It is recommended that each unit’s AC input be connected to the AC supply circuit of a separated power
source system. Any unit (s) for which a separate power source system is not available, is (are) recom-
mended to be connected to a UPS (Uninterruptible Power Supply).
Option
Option name Description
HK-PSU03 Backup Power Supply Unit
The power cord is not supplied with the DCU-8000.
It is necessary that the power cord should be applicable to places in the area.
Power cord
Area Specification Length Part No.
Japan 125 V 10 A 2.5 m 1-776-997-11
*3P - 2P (adaptor) *1-750-686-11
USA/Canada 125 V 10 A 2.4 m 1-557-377-11
All Europian countries 250 V 10 A 2.4 m 1-782-929-21
To Next Page
Loading...
