1-25
CCP-8000 IM
1-10. Checks on Completion of Installation
<TEST terminal>
E1 (A-2) : GND pin
Used for GND when measuring each check terminal.
TP8 (A-2) :
++
++
+12 V check pin
+12 V measuring terminal.
<LED on the CPU DR module> : Main CPU
D10 (green) (A-1) : RUN status LED
RUN status indication.
Lit when the CPU-DR module starts operating.
D12 (green) (A-4) : CD (Card Detect) status LED
Lit when the CPU-DR module is inserted correctly to the
parent board.
D13 (green) (A-1) : +2.5 V
Indicates the statue of the +2.5 V power that is generated
by the VCC (CORE) and supplied to the CPU-DR module.
Lit while the specified power is turned on.
D14, D15, D16, D17 (A-3) (green) : STATUS1 to
STATUS4 status LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
D18 (green) (A-4) : +3.3 V
Indicates the status of the VCC (I/O) power that is supplied
to the CPU-DR module.
Lit while the specified power is turned on.
D19 (green) (A-4) : CORE status LED
Indicates the status of the VCC (CORE) power that is
supplied to the CPU-DR module.
Lit while the specified power is turned on.
<Switch on the CPU DR module> : Main CPU
SW1 (A-2) : RESET switch
Pressing this switch resets the CPU-DR module.
n
In some machines in which the CPU-DR module is
installed, the system reset may be activated.
SW2 (A-2) : MODE switch
8-pin DIP switch
Used only for production in the assembly factory. All
switches are set to OFF for normal operation.
<LED on the CPU DK module> (COM0) (COM1)
DI1 (green) (B-5) : CD (Card Detect) status LED
Lit when the CPU-DK module is inserted correctly to the
parent board.
DI2 (green) (F-3) : RUN status LED
Lit when the CPU-DK module starts operating.
DI3 (F-3) (green) : STATUS4 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI6 (F-3) (green) : STATUS3 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI7 (F-3) (green) : STATUS2 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI8 (F-4) (green) : STATUS1 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI4 (green) (B-5) :
++
++
+3.3 V
Indicates the status of the VCC (CORE) and VCC (I/O)
powers that are supplied to the CPU-DK module.
<Switch on the CPU DK module> (COM0) (COM1)
SW1 (D-5) : RESET switch
Pressing this switch resets the CPU-DK module.
n
In some machines in which the CPU-DK module is
installed, the system reset may be activated.
SW2 (C-5) : MODE switch
8-pin DIP switch
Used only for production in the assembly factory. All
switches are set to OFF for normal operation.
Default setting when shipped from the factory is all OFF.
To Next Page
Loading...
