2-8
CCP-8000 IM
2-5.
Connecting the MKS-8075/MKS-8076
Structure of MKS-8075 (Connecting the extension
adaptor)
Adaptor case : 1
Screw (BV3 x 10) : 4
Connecting plate A : 1
Connecting plate B : 1
Connecting plate C : 2
Panel cover (L) : 1
Panel cover (R) : 1
Cable (D-sub 50-pin): 1
Structure of MKS-8076 (Memory card/USB adaptor)
Adaptor case : 1
Screw (BV3 x 10) : 4
Connecting plate A : 1
Connecting plate B : 1
Connecting plate C : 2
Panel cover (L) : 1
Panel cover (R) : 1
2-5-1. How to Connect the MKS-8075 and the
MKS-8076
m
. A maximum of eight extension adaptors can be connected
either horizontally, or vertically.
(Up to two extension adaptors can be connected horizon-
tally.)
(For an example of connection, refer to Fig. 1.)
. There are three methods of vertical connection as
described below. (Refer to Fig. 2. (page 2-11))
Method A : Install the extension adaptors on the panel so
that they have differences in height like a
flight of steps and with the same outside
appearance as that of the main panel.
Method B : Install the extension adaptors flat on the
panel with no difference in height.
(In such a case as installed on tabletop)
Method C : Install the extension adaptors in the rack.
(Horizontal connection is also required.)
. When extension adaptors are installed using both
horizontal and vertical connections, be sure to perform
the vertical connections first then perform the horizontal
connections.
. When an MKS-8076 is to be installed, install it in the
top-most position. (Refer to Fig. 1.)
. When the vertical connection (A) is selected, be sure to
secure all of the side panels with screws. Never panel it a
table top. (The fixing method is same as that of the main
panel.)
Fig. 1
2-5. Connecting the MKS-8075/MKS-8076
: The position where the MKS-8076 can be connected
Number of
connections
2345678
To Next Page
Loading...
