Sony CCP-8000 - Page 50

2-10
CCP-8000 IM
(3) Fix the bottom plate of the adaptor cases at the loca-
tions shown in the illustration using the 4 connecting
screws (BV3 x 10) and 2 of the connecting plates B
for every 2 adaptor cases.
n
When the Vertical connection (A) is selected, there are
several locations where the connecting plate B cannot
be fixed.
5. Install the side panel.
n
The screw positions that fix the side panel are different
in the connection methods (A), (B) and (C) respective-
ly. (refer to Fig. 2 (on page 2-11).)
6. Install the operation module and fix it by tightening
the four screws on the sides.
BV3 x 10
BV3 x 10
Adaptor cases
Connecting plate B
BV3 x 10
BV3 x 10
Module covers
Cap (L)
Cap (R)
2-5. Connecting the MKS-8075/MKS-8076
7. For connection methods (A) and (B) (refer to Fig. 2
(on page 2-11).), install the caps (L) and (R), and the
module cover in the direction of the arrow.
For connection method (C) (refer to Fig. 2 (on page 2-
11).), remove the four stepped screws and install the
panel covers (L) and (R).
Stepped screws
M3
Stepped screws
M3
Panel cover (R)
Panel cover (L)