You can make a program by designating up to 24 selections in desired order. At the
same time, you can adjust the total playing time of the program, so that you can
make the program fit the length of a tape when recording.
_2-A- _
_3
5
Onlvf"_rCDP _9_' 1, 2-B2) 2-B1)
Pressthe PROGRAM button.
"PROGRAM" appears in the display.
PROGRAM
(
Press the numeric buttons of the desired
selections in desired order (only on the remote
commender).
2 8 5
Last programmed selection
I
pROGRAM _--_
i
The order to be played Programmed selection
numbers
After one second, the total playing time is displayed.
To select a selection number over 10, see page
9.
If you choose wrong selections
Each time you press the CLEAR button, the last
chosen selection is deleted.
1) Press the I<_ <1<(1_1<1)or IH_ I_b,I(IHH) button to
change a selection and check the time. - Program
edit
[}<3<141<1 I_b"D_>0
I I I
Lastselection
I ,
I
_ .,. _Ec [ 2 ._ | |
'" =-r:
I
Total playing time Selection numbers
Total playing time of selections is displayed
If satisfactory, go to the next step. If not, choose
another selection.
2) Press the PROGRAM button to store the
selection.
Step number appears in the display for a while.
PROGRAM
STEP 2 5
ILl _ 8 lo
PROeP,I_
3) Repeat steps 1) and 2)
Press the II button on the remote commander to
make a program for side B.
"P" is displayed inthe display and the total playing
time is reset to 0. A pause is also counted as a
selection.
UoUU _ 8 10
pROGRAM
19
To Next Page
Loading...
