You can end the play lading out by designating the play duration. Once the time lade
is set, it functions twice for editing both sides of a tape. You can change discs without
cancelling this function and use it in any play mode.
3
EC3_ ®
2
'4
1
Press the EDIT/TIME FADE button three times in
stop mode, (or press it once in pause mode).
"TIME FADE" and "A" in the tape indicator displayed
in the display.
EDIT.rrlMEFADE
Press the I<1<4'< or IH_ IHH to set the desired
play duration.
0<]<_ _1<1 IH_ DE>[]
I':" "I I
5
1 2 3 4 5
r _6
L-- _L____, 6 7 8 9 10
TIME
_ 11 12
Each time you press the I<1<<1<or IH_ IH_I button,
the play duration for one side of the tape is
displayed as follows.
HALF e-._C-46 4-) C-54 <-->C-60
(23.00min) (27.00min) (30.OOmin) I
--.-- 4--)C-90<--)C-74 _ /
(45.00rain) (27.00rain)
When using the remote commander (only for
CDP-397)
To set the time for one side of the tape as you
want, press the numeric buttons.
Press [] for "0".
You need not press buttons for the seconds, unless
required.
Press the IINII (1_) button to start playing.
Before the unit enters pause mode at the set time
with "B" illuminated in the tape indicator, play starts
fading out for a specified duration (see page 18).
To start play for the other side of the tape
Press the HI (1_or II) button.
The unitenters pause mode at the set time by fading out for
a specified duration.
When this play ends, time fade is cancelled.
To cancel time fade
Press the EDIT/TIME FADE button again.
Time fade is also cancelled when the I_1<<1<(<<l)or IH_ IHH
(IH_) button is kept pressed.
To display the time remaining until the set time
Press the TIME button twice.
Whenplayendswithinthedesignatedpedod
Timefadefunctioniskeptactive.Changediscsandstartplay.Whenthetotalplayingtime
ofthediscsreachesthedesignatedperiod,theunitpausesbyfadingout.
24
To Next Page
Loading...
