l_j _] I_ [,._
_Jk._ I_ I_"_l_ m _._IE._
[=3
m
(Only for CDP-397
I I I 1'1
i i i .................. i}
I]<3<3_1_1 INl_ I>1>1]
E30_
lw--- _ --It
--H4
m
(Onlyfor CDP-397)
I I
, ; ...............;....
You can locate the beginning of a desired selection in two
ways.
a) To locate sequentially
To locate the beginning of the current or preceding
selection
• Press the I<1<1<<1 (1<1<1)button as many times as required.
• Keep the I<< <1< (1<1<1)button pressed to skip selections
(operable only in stop mode when using the buttons on
the main unit).
To locate the beginning of a succeeding selection
• Press the IH_ IHH (IHH) button as many times as required.
• Keep the IH_ IHH (IHH) button pressed to skip selections
(operable only in stop mode when using the buttons on
the main unit).
Whenyoupress the 144<4 (14<1)buttondudngplay
Theunitlocatesthebeginningoftheselection.
b) To locate directly with the remote commander
(only for CDP-397)
Press one of the numeric buttons ( [] to [] ) to enter the
desired selection number.
If a selection number is greater than 10, use the _ and []
to [] buttons. [] functions as the figure 0.
e.g. To play from selection No.22
Press_ [] []
e.g. To play from selection No.30
Press _ [] []
Youcanalso locate a particularpointina disc duringplay in
two ways.
a) To search quickly while monitoring the sound
Forward locating at high speed
The _,1_IH_I (IH_) button pressed during play and release it
at the desired point.
Reverse locating at high speed
Keep the I<1<<1<1(4<1) button pressed during play and
release it at the desired point.
b) To search quickly by observing the display
Press the IHI (11)button, then keep the I<1<1<1<1(<1<1)or
IH_ IHH (IH_) button pressed. The search speed will increase,
but there will be no sound. Find the desired point by
observing the display.
Press the I_ II (l_or II) button again at the desired point.
When'_ is displayed
IfyoucontinuouslypresstheI_ _I,I (1,_,)buttonoverthelastselection,""_'_"
appearsinthedisplay.PresstheI_ 44 ( 144or4< ) buttonto returntonormal
indication.
9