Sony CDP-3100 - Page 2

For the customers in the U.S.A.
WARNING
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user will be required to correct the
interference at his own expense.
You are cautioned that any change or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
The shielded interface cable recommended in this manual
must be used with this equipment in order to comply with
the limits for a digital device pursuant to Subpart B of Part
15 of FCC rules.
CAUTION
As the laser beam used in this compact disc player is
harmful to the eyes, do not attempt to disassemble the
cabinet. Refer servicing to qualified personnel only.
For the customers in Canada
This apparatus complies with the Class A limits for radio
noise emissions set out in Radio Interference Regulations.
Pour les utilisateurs au Canada
Cet appareil est conforme aux normes Class A, pour bruits
radioélectriques, spécifiés dans le Réglement sur le
brouillage radioélectrique.
11117
WARNING (For the customers in the United Kingdom)
THIS APPARATUS MUST BE EARTHED
IMPORTANT
The
wires
in
this
mains
lead
are
coloured
in
accordance
wit
the following code: ;
Green-and-yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured markings ;
identifying the terminals in your plug proceed as follows:
The wire which is coloured green-and-yellow must be
connected to the terminal in the plug which is marked by thr:
letter E or by the safety earth symbol + or coloured green |
or green-and-yellow. The wire which is coloured blue must .
be connected to the terminal which is marked with the letter :
N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.