Sony CDP-3100 - Mechanism Deck Replacement

chapter 3 Illi
3-2
3-1 Precautions
3-1-2 Handling Precautions —
Install the player on a flat surface in a temperature-controlled room.
Avoid using or storing the player in any of the following locations:
¢ Extremely hot or cold locations
¢ Damp locations
« Locations subject to severe vibrations
* Locations subject to strong magnetic fields
« Locations subject to many hours of direct sunlight and locations
close to heating equipment
ce we
« Check the player’s operating voltage before you plug it in. It must
be identical with that of your local power supply. See “Operating
Voltage”.
+ If you drop any liquid or metal object inside the player, immediately
stop using it, unplug the power cord from the socket, and contact
Sony service personnel.
¢ If the player will be unused for a long time, make sure to unplug its
power cord from the socket. When unplugging the power cord,
grasp it by the plug, not the cord.
¢ Never remove the cabinet. The laser light used in the player can
cause damage to your eyes. If the player needs to be inspected,
contact Sony service personnel.
Condensation
If Trouble Occurs
Bringing in the player from a cold place or turning on the room
heating may cause moisture to condense on the lens within the player,
resulting in abnormal operation. If this occurs, leave the power on.
The moisture will evaporate within an hour and the player will
function normally again. If the player does not operate normally after
a few hours, contact Sony service personnel.
AC Power Cord
Operating Voltage
Chapter 3 Preparations
Should you detect abnormal noise, smell, or smoke, immediately turn
off the power, unplug the power cord from the socket, and contact
Sony service personnel.
Do not use any power cord other than the one supplied with the
player.
U.S.A. and Canada model 120 V AC, 60 Hz
European model 220 - 230 V AC, 50/60 Hz :
U.K. model 240 V AC, 50 Hz