Sony CDP-3100 - Jog Mode; Standby Mode

chapter 4 lil
4-1 Overview of Player Operations
The player has the five following modes:
¢ JOG mode
¢ STANDBY mode
« Monitor play mode
* On-line play mode
¢ STOP mode
JOG Mode
Use this mode to set cue points.
Activating the mode: Press the JOG key on the control unit, so that
its indicator lights up.
Result: The track section corresponding to the point when the JOG
key is pressed plays repeatedly. (If the player is in STOP mode
when you press the JOG key, the section corresponding to the
point when the STOP key was pressed repeats.)
Subsequent operations: Set the cue point with the JOG dial or the
numeric keys. The counter in the disc data indication section
shows the entered cue point as SET TIME data.
STANDBY Mode
Use this mode to place the player in standby mode at specified cue
points.
Activating the mode: Press the STANDBY key on either the front
panel of the player or the control unit.
Result: The pickup stops at the same position over the span of a
single disc rotation starting from the specified cue point. Monitor
output is muted at this time.
Subsequent operations: Press the PLAY key to start playback
from the cue point.
Press the BEGIN key to listen to the beginning of the current
track. The audio signal is output as long as you hold down the
key. Press the END key to listen to the final 15 seconds of the
current track.
4-2 Chapter 4 Operations