Sony CDP-400 - Page 19

CDP-400/501 /SOI1ES/61 OES |
Remove bottom plate.
+BVTT 3x 8 (with claw)
2
Loading Switch Board
Q loading switch board $920 (chucking motor}
6 @ P3x3
Osvrr2 Bc6 @ microswitch mounting plate (8)
Chucking Motor (M2)
~~ @ P26x5
: “~~@ motor mounting plate (8)
white wire from CNJ7 ¥
\ 2
yellow wire from loading switch board Soff
a
; CDP-400/501 /SOTES/610ES
Remove bottom plate
+BVTT 3 x 8 (with claw)
+
Optical Sied Motor Block @P2.6x5 (2 pes.)
optical sled motor (M3)
Optical Sted Motor Assembly
® &-3
© gear (0) x0 washer
Ne :
O gear (Cc) eS)
eyeo——G £3
o~—__g washer
@® stainless steet
balf ‘> °
@ thrust
screw
motor holder \ \ ® P26x5
afign the teeth of the gears (A) and {B).
Metea ie Soe ote
Note for assembly:
When installing the racks {A} and (B),
align the rack teeth by inserting a pin
into this hale,
Apply grease /
®@r26x5 SGL-501 ay white:
@
gear
spring
~C)
41
ING
ES
*
;
|
from
CNJ8
{
SYS
}
blue:
@
gear
(A)
AS)
—
Pp
~
:
3
Q Insert a pin or the like into this hole to
rack (B) rack (A}
® optical sled motor (M3)
install the motor so that the cutouts
are located in upper side.)
@® Align the teeth of the gears
. C) and (D).
49 ~~