Sony CDP-400 - Disc Playing; Search Operation

1-5. OPERATIONS
DISC PLAYING
TO PLAY
Amplifier
1 Turn the amplifier on and set the input selector to the CD player
position.
Depress the POWER switch (a ON).
Press the OPEN/CLOSE button. The DISC indicator flickers and
the disc compartment opens.
4 Put the disc in place with the label surface up.
§ Press the m PLAY button. The compartment closes and play
begins from the beginning of the disc.
On
If you press the mm button to select the desired selection with the
compartment open, then press the # PLAY button, the compart-
ment will close and play will begin from that selection.
if you press the If PAUSE button when the compartment is open,
the compartment will close and the disc will pause at the beginning
of the first selection.
When the player reaches the end of the Jast selection of the disc, it
is automatically reset to the beginning of the disc and stands by.
To open the compartment, press the OPEN/CLOSE button.
An important point to remember
in the CD system, a wider dynamic range is achieved than
that of the conventional analog system, and the peaks of
high level inputs are recorded with high-fidelity. In addition,
the noise level is very low.
(f you turn up the volume inadvertently while listening to a
portion where no audio signals or very low level inputs are
recorded, the speakers may be damaged when the portion
with peak levels is played.
| €DP-400/501 /501ES/610ES
CDP-400/501/501ES/610ES
Label surface
COP-400 etc.
TO STOP DURING PLAY
To open the compartment
Press the OPEN/CLOSE button. The disc will stop rotating and the
compartment will open.
To pause for a moment during play
Press the #§ PAUSE button. The §# indicator will illuminate.
To retease pause and restart play from the same point, press the 18
PAUSE button again.
To reset to the beginning of the first selection
Press the STOP (RESET) button. The player will stand by.
To stop at the end of each selection — Auto pause
When the AUTO PAUSE switch is depressed, the indicator at the
left lights. When the indicator lights. the player automaticalty
enters pause mode at the end of each setection and the §§ indicator
lights. Ta resume playback. press the §# PAUSE button. Playback
starts from the beginning of the following selection. To release the
auto pause mode, press the AUTO PAUSE switch again.
SEARCH OPERATION
TO SEARCH FOR A PARTICULAR SELECTION— AMS (Automatic Music Sensor) function
Using the w@ cr B® Dutton. you can quickly locate a desired selection anead or back. When the button is pressed, the
piayer searches the selection data recorded at the beginning of each selection and piay will start from the beginning of
the selection
To search tor a back selection
Press the ~@q@ Dutton during play or
pause.
When the = button is pressed once,
the deginning of the selection being
played !s searched for.
Each time the button is pressed, one
selection dack is searched for
being played
When the 8th selection is
Beginning of the
Press.
Keep the m@ button pressed until the desired music number is displayed.
If you press the mq Dutton after the first selection is located, the TRACK indicator will not change.
To search tor a selection ahead
Press the B® button during play or
pause.
When the @ button is pressed once,
the next selection after that being
played is searched for.
Each time the Dutton is pressed, the
selection ahead is searched for.
8th setection
9th selection
> a
Keep the Bi button pressed until the desired music number is displayed.
'f you press the S41 button after the ast selection is located, the TRACK indicator will not change.
—16—-—
tn selection
Play starts.
Beginning of the 71h selection
ab '
Play starts.
Press again
10th selection
; Press again.