Sony CDP-C265 - 4-2. CIRCUIT BOARDS LOCATION; 4-3. SEMICONDUCTOR LEAD LAYOUTS

Playing CDs
¢ The program remaigs until you erase it or turn off the
player :
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that aren’t found in the player or on the disc are
deleted from the program, and the rest of the program is
played in the programmed order.
Note
The total playing time doesn’t appear when:
—You have programmed a track whose number exceeds 20.
—The total playing time of the program exceeds 200 minutes.
Checking the track order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
track (the disc and track numbers) or the disc (the disc
number and “AL” indication) of each step in the
programmed order.
After the last track in the program, the display shows
“End” and returns to the original display. If you check
the order after you start playing, the display shows
only the remaining steps.
Changing the track order
You can change your program before you start playing.
a i ne
To Press
Erase a track CHECK until the track you
don’t want appears in the
display, then press CLEAR
Erase the last track in the CLEAR. Each time you press
program the button, the last track will
be cleared.
Add tracks to the end of the DISC 1 —5 to select the disc,
program then number buttons of the
tracks to be added
Change the whole program @ (stop). Create a new
completely program following the
programming procedure.
Recording From CDs
ae a ee ray
Recording Your Own Program
You can record the program you’ ve created on a tape,
etc. The program can contain up to 32 tracks.
By inserting a pause during programming, you can
divide the program into two for recording on both
sides of a tape.
PROGRAM DISC 1-5 cm il
Number buttons >10
1 Create your program while checking the total
playing time indicated in the display.
Follow Steps 1 to 4 in “Creating Your Own
Program” on page 10.
The [&] indication appears in the display.
2 When you record on both sides of the tape, press
All to insert a pause.
The
“P”
and
[45]
indications
appear
in
the
display
and the playing time is reset to “0.00.”
When you record on one side of the tape, skip this
step and go to Step 4.
A pause is counted as one track
You can program up to 31 tracks when you insert a
pause.
3 Repeat Steps 2 to 4 in “Creating Your Own
Program” on page 10 to create the program for
side B.
4
Start
recording
on
the
deck
and
then
press
[>
on
the
player.
When
you
record
on
both
sides
of
the
tape,
the
player
pauses
at
the
end
of
the
program
for
side
A.
5 When you record on side B, reverse the tape and
y' P'
press [> or ll on the player to resume playing.
¢ You can check the total playing time while
programming (program edit)
To select a track, press IK] or D1 and check the total
playing time. Then press PROGRAM to confirm your
selection.
pe To check and change your program
See the left column of this page.
The
(4-0)
indication
appears
while
checking
the
program
for
side
A
and
[a5]
while
checking
the
program
for
side
B.
11