Sony CDP-C265 - 2-3. OPTICAL PICK-UP BLOCK ASSEMBLY; 2-4. BRACKET (GEAR) ASSEMBLY

Display informatign while playing a disc
While playing a disc, the display shows the current
disc number, track number, playing time of the track
and the music calendar.
Current disc number
Playing time
Current track number Music calendar
The track numbers in the music calendar disappear
after they are played.
Checking the remaining time
Each time you press TIME while playing a disc, the
display changes as shown in the chart below.
Playing time and
—"DIIDA
number of the _ a Se
current track ! i LL56
Press TIME. i
If the track number exceeds 24,
-~.—~—” appears instead of the
remaining time.
Press TIME. I
Remaining time
on the current
track
“a
Remaining time
on the disc
This information is available only in
continuous play mode.
Playing CDs
is cee eS |
Replacing Discs While Playing
a Disc
You can open the disc tray while playing a disc so that
you can check what discs are to be played next and
replace discs without interrupting playback of the
current disc.
EX-CHANGE
DISC SKIP
1 Press EX-CHANGE.
The disc tray opens and two disc compartments
appear. Even if the player is playing a disc, it
doesn’t stop playing.
2 Replace discs in the compartments with new ones.
The player plays the disc on the left side
compartment after the current disc, and then the
one on the right side compartment.
3 Press DISC SKIP.
The disc tray turns and other two disc
compartments appear.
4 Replace discs in the compartments with new ones.
Press EX-CHANGE.
The disc tray closes.
Notes
¢ If the playback of the current disc ends while the disc tray is
open, the player stops playing. If the disc is played in
1 DISC repeat mode (see page 9), the current disc starts
playing again.
e In ALL DISCS shuffle mode (see page 9), tracks are
reshuffled on the current disc, while the disc tray is open.
¢ In program mode (see page 10), only the tracks on the
current disc are played.
¢ Do not push the disc tray to close it in Step 5, as you may
damage the player.