Hookups
When connecting an audio cord, be sure to mateh tile
color-coded cord to tile appropriate jacks on tile
components: Red (right) to Red and White (left) to
White. Be sure to connect firmly to avoid hLlnl and
noise.
CD player Amplifier
"_) If you have a Sony component with the CONTROL
AIII (or CONTROLA1)jack
Connect the component via the CONTROL AlE (or
CONTROL A1)jack. You can simplify the operations of
audio systems composed of separate Sony components.
For details, see "Using the CONTROL AIlI Control
System" on page 33.
Connecting the AC power cord
Connect the AC power eord to a wall outlet.
• If you have a digital component such as a digital
amplifier, D/A converter, DAT, or MD
Connect the component via tbe DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.
Note that you cannot use fading in or out (page 22).
Optkal cable (not supplied)
CD player Digital component
Note on placement of the player
Be sure to place tile player on a flat, horizontal place.
If tile player is left on a slanted position, it may cause a
malfunction or damage tile player.
×
Notes
•The playback fl'om an MP3 file is not output fl'om the
DIGITAL OUT (OPTICAL) connector.
• When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software
other than music, such as a CD ROM.
7LJS
To Next Page
Loading...
