– 38 – – 39 – – 40 –
5-11. SCHEMATIC DIAGRAM — MAIN SECTION (2/2) —
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
4
W or less unless otherwise
specified.
• C : panel designation.
• U : B+ Line.
• Voltage is dc with respect to ground under no-signal
(detuned) condition.
no mark : FM
( ) : TAPE (PB)
< > : TAPE (REC)
[ ] : CD STOP
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
Note: The components identified by mark ! or dotted line
with mark ! are critical for safety.
Replace only with part number specified.
(Page
30)
(Page 31) (Page 35)
(Page 35)
(Page 30, 35)
CFD-S45L/S47L
To Next Page
Loading...
