Sony DCR- TRV15 - Types of Trouble and Their Solutions

Types of trouble and their solutions
Symptom Cause and/or Corrective Actions
The power does not turn on. • The battelT pack is not installed, o1"is dead o1"nearly dead.
">Install a charged batte W pack. (p. 12, 13)
• Tile AC power adaptor is not connected to a wall outlet.
">Connect tile AC power adaptor to a wall outlet. (p. 17)
The end search function does not • The tape was ejected after recording when using a tape
work. without cassette memo1T. (p. 30)
• You have not recorded on tile new cassette yet. (p. 30)
The end search function does not • The tape has a blank portion in tile heginning o1"middle.
work correctl>
The battery pack is quickly • The operating temperature is too low.
discharged. • Tile batte W pack is not flllly charged.
">Charge tile batte W pack again. (p. 13)
• The battelT pack is completely dead, and cannot be
recharged.
+ Replace with a new hattel T pack. (p. 12)
The battery remaining indicator does • You have used the battery pack in an extremely hot or
not indicate the correct time. cold environment tbr a long time.
• The battelT pack is completely dead, and cannot be
recharged.
">Replace with a new hatte W pack. (p. 12)
• Tile batte W is not thlly charged.
+ Charge tile hatte W pack flflly again. (p. 13)
• A deviation has occured in the remaining battel T time.
+ Charge tile hattel T thlly. (p. 13)
The power goes off although the • A deviation has occured in the remaining hatte W time.
battery remaining indicator indicates + Charge tile batte W pack flllly again so that the indication
that the battery pack has enough on the battelT remaining indicator is correct. (p. 13)
power to operate.
The cassette cannot be removed fl'om • Tlle power source is disconnected.
the holder. ">Connect it firmly. (p. 12, 17)
• Tile batte W is dead.
">Use a charged battery pack. (p. 12, 13)
The [] and _"indicators flash and no • Moisture condensation has occurred.
functions except fbr cassette qection ">Remove tile cassette and leave your camcorder tbr at
work. least one hour to acclimatize. (p. 165)
(_1_indicator does not appear when • Tile gold plated connectoc of tile tape is dirty o1"dusty.
using a tape with cassette memory ">Clean the gold plated connector. (p. 158)
Remaining tape indicator is not • The _ REMAIN is set to AUTO in the menu settings.
displayed. + Set it to ON to always display the remaining tape
indicator. (p. 101)
(continued on tbe fbllowing page)
-,t
0
151