Using the built-in light
Use the Sony XB-3D halogen lamp (optional). The supplied halogen lamp is not
commercially available. Purchase the Sony XB-3D halogen lamp.
Remove the power source before replacing the bulb.
(1) Remove the built-in light unit while pushing the hole under the built-in light
unit using a wire.
(2) Turn the bulb housing counterclockwise and detach from the built-in light
unit.
(3) Replace the bulb using a d_T cloth.
(4) Attach the bulb housing by turning it clockwise, then replace the built-in light
unit.
2 3
NOTE
Be sure to align the tab with
the groove when inserting.
=>
o
==
o
• When replacing the bulb, use only the Sony XB-3D halogen lamp (optional) to reduce
tile risk of fire.
• To prevent possible burn hazard, disconnect the power source before replacing and
do not touch the bulb until the bulb becomes cool enough to handle (for about 30
minutes or more).
Note
To prevent the bulb from being smudged with finger prints, handle it with a dry cloth,
etc. If the bulb is smudged, wipe it thoroughly.
81
To Next Page
Loading...
Need help?
General