66
Turn the LCD panel over and move it back to your camcorder body with the LCD
screen facing out. You can operate with the touch panel using the viewfinder.
Use the viewfinder when operating camera brightness and fader on the touch panel.
The POWER switch should be set to or .
Operate by touching the panel.
(1) Turn the LCD panel over and move it back to your camcorder body with the
LCD screen facing out.
(2) Press
OFF. The PANEL OFF indicator appears on the screen.
(3) Press OK. The LCD screen is turned off.
(4) Using the viewfinder, press the LCD screen. EXPOSURE,
OK, ON and
FADER (only when the POWER switch is set to CAMERA) appear.
(5) Press the LCD screen and select a desired item, then press
OK.
EXPOSURE: Adjust the exposure by pressing –/+.
FADER: Press FADER until a desired fader mode appears.
The indicator changes as follows:
FADER t M. FADER t BOUNCE t MONOTONE
(no indicator) T DOT T WIPE T OVERLAP
ON: The LCD screen lights up.
To make the buttons on the LCD screen disappear
Press OK.
Using the viewfinder
4
ON
OK
EXPO–
SURE
EXPO–
SURE
OK
ON FADER
When the POWER
switch is set to CAMERA
When the POWER
switch is set to MEMORY
Viewfinder
To Next Page
Loading...
Need help?
General