30
Automation Operation
Automation Operation
Automation Isolate
General
Complete channels or sections of channels can be set
into an isolate mode in order that automation data will
not affect control settings.
Isolating Channels or Sections of All
Channels
1 Touch the {AUTOMATION} label in the middle at
the bottom of the GUI to display the
AUTOMATION GUI.
2 The {AUTOMATIONISOLATE} tab in the upper part
of the GUI is the default and should already be
selected.
3 Touch the {ALLON} button to highlight all channel
and signal paths green. Or touch individual
buttons relating to channels and outputs, if more
appropriate, to highlight them green. The
automation data will be isolated from all
highlighted channels, leaving their controls free for
adjustment.
4 Alternatively, under the FUNCTION heading,
touch ‘section’ buttons according to what is to be
isolated on a mixer-wide basis:
• {EQ/FILT} for all Equaliser and Filter sections.
• {DYN} for all Dynamics sections.
• {AUXSND} for all Aux Send controls.
• {CUT} for all Channel, MTR and Aux Return
Fader Cuts.
To Next Page
Loading...
Need help?
General
