5
Automation Operation
The Title for any project is the heading under which all
related data, such as mixes, snapshots and cue points, is
held. So, although not vital, it is a good idea to have a
Title name for any project right from the start.
To Name a Title
1 Touch {SYSTEM} for its pop-up and then touch
{TITLEMANAGER} to access the TITLE
MANAGER GUI.
2 Touch the NAME line in the INFORMATION
block in the centre of the GUI, and the QWERTY
Keyboard pop-up appears.
3 ‘UNTITLED’ will be displayed by default in the
upper entry dialogue line for a new system. Either
touch {BACKSPACE} several times to delete it, or
touch and move a finger across it to highlight it.
Then type in a Title name using the touch
QWERTY keyboard. Touch {ENTER} when
finished.
From now on, any changes in settings will relate to
the Current Title which has just been named. The
data for this Title resides in the system Dynamic
RAM.
Note
Data left in RAM will be lost if the system is powered down.
Use KEEP or SAVE to retain it.
Titles
To Next Page
Loading...
Need help?
General
