Sony DR-BT50 - Listening to Music

OPERATING THE UNIT
Listening to music
(RIGHT)
POWER button
LJ - button -H-"""-
LJ + button ~~L...l
Jog switch
VOL + button -'-'
VOL - button ---
Jog switch
operation
Check the following before
operating the unit.
- The Bluetooth device is turned
on.
- Pairing
of this unit and the
Bluetooth device is complete.
- The Bluetooth device supports the
transmitting music function
(profile: A2DP*).
1 Press and hold the
POWER button for
about 3 seconds while
the unit is turned off.
The indicator (blue) and
indicator (red) flash together
twice and the unit is turned on.
Notes
• Do not press and hold the POWER
button for more than 7 seconds,
otherwise pairing mode is entered.
• After the unit is turned on, the unit
attempts to connect to the last
connected Bluetooth device
automatically with
HFP or HSP. To
make or receive a call while
listening to music, make ready the
last connected Bluetooth device for
HFP or HSP connection before
turning on the headset.
2 Make the Bluetooth
connection (A2DP) from
a Bluetooth device to
this unit.
Refer to the operating
instructions supplied with the
Bluetooth device on how to
operate it.
3 Start playback on the
Bluetooth device.
Tip
Bluetooth connection of A2DP
(Advanced Audio Distribution Profile)
can also be operated with the
jog switch
from this unit to the Bluetooth device
except when making a call on this unit.
Note
When you play music by connecting the
unit to a Bluetooth device using
HSP
(Headset Profile), sound quality will not
be high.
For better sound, change the
Bluetooth connection to
A2DP by
operating the Bluetooth device.
* For detail on profiles, see page 23.
Continued 13
us