Calling
[8J
To make a connection
by operating Bluetooth
mobile phone
1 Make the Bluetooth
connection (HFP or
HSP*) from the
Bluetooth mobile phone
to this unit.
Refer to the manual supplied
with your Bluetooth mobile
phone for operation details.
The list
of
recognized devices
appears on the display
of
the
Bluetooth mobile phone. This
unit is displayed as "DR-BT50."
When you use the Bluetooth
mobile phone features both HFP
(Hands-free Profile) and HSP
(Headset Profile), set to HFP.
Note
When connecting to a Bluetooth
mobile phone which is different from
the last connected one, make the
connection following the above
procedure.
* For details on profiles, see page 23.
(RIGHT)
When this unit does not
connect to a Bluetooth
mobile phone automatically
You can make a connection by
operating Bluetooth mobile phone
or by operating this unit to connect
the last connected Bluetooth device.
Tip
This unit will stop trying to connect
to the Bluetooth mobile phone after 1
minute.
In such a case, press the multi
function button to try to connect
ag3.1n.
1 Press and hold the
POWER button for
about 3 seconds while
the unit is turned off.
The indicator (blue) and
indicator (red) flash together
twice, the unit turns on and then
this unit tries to connect to the
last Bluetooth mobile phone that
was used.
Note
Do not press and hold the POWER
button for more than 7 seconds,
otherwise pairing mode is entered.
Multi function
button
~~v
POWER
button
......
-~-'
VOL + button
VOL - button
__
J
Check the following before
operating the unit.
- The Bluetooth function is active
on the mobile phone.
- Pairing
of
this unit and the
Bluetooth mobile phone is
complete.
16
us
To Next Page
Loading...
