part meets the IRE level that you set. Use this zebra pattern as a guide to adjust
the brightness.
1. MENU → (Custom Settings) → [Zebra] → desired setting.
Menu item details
Off:
Does not display the zebra pattern.
70/75/80/85/90/95/100/100+/Custom1/Custom2:
Adjusts the brightness level.
Hint
You can register multiple values for [Zebra] to check the exposure and the flare
as well as the brightness level. The settings for exposure confirmation and flare
confirmation are registered to [Custom1] and [Custom2] respectively by default.
To check exposure, set a standard value and the range for the brightness level.
The zebra pattern will appear on areas that fall within the range you set.
To check flare, set a minimum value for the brightness level. The zebra pattern
will appear on areas that exceed the value you set.
Note
The zebra pattern is not displayed during HDMI connection.
[92] How to Use Using shooting functions Adjusting the exposure
Exposure Set. Guide
You can set whether to display a guide when you change the exposure.
1. MENU → (Custom Settings) → [Exposure Set. Guide] → desired setting.
Menu item details
Off:
Does not display the guide.
On:
Displays the guide.
To Next Page
Loading...
