Hint
In [Spd Priority Cont.] mode, the focus is determined when you press the
shutter button halfway down for the first image, and locked for subsequent
shots. However, the camera can continue adjusting the exposure for
subsequent shots. To keep adjusting the exposure throughout the continuous
shooting, set the settings as follows:
Set [ AEL w/ shutter] to [Auto] or [Off].
[97] How to Use
Using shooting functions Selecting a drive mode (Continuous
shooting/Self-timer)
Self-timer
Shoots an image using the self-timer after a designated number of seconds have
elapsed since the shutter button was pressed.
1. MENU → (Camera Settings) → [Drive Mode] → [Self-timer].
2. Select the desired mode using the right/left side of the control wheel.
Menu item details
Self-timer: 10 Sec:
Sets the 10-second delay self-timer.
When you press the shutter button, the self-timer lamp flashes, a beep sounds,
and the shutter operates after 10 seconds. To cancel the self-timer, press the
shutter button again.
Self-timer: 5 Sec:
Sets the 5-second delay self-timer.
When you press the shutter button, the self-timer lamp flashes, a beep sounds,
and the shutter operates after 5 seconds. To cancel the self-timer, press the
shutter button again.
Self-timer: 2 Sec:
Sets the 2-second delay self-timer. This reduces the camera-shake caused by
pressing the shutter button.
Hint
To Next Page
Loading...
