Help Guide
Marine Audio
DSX-M80
General Setup (GENERAL)
DEMO (demonstration)
Activates the demonstration: [ON], [OFF].
CLOCK (clock)
Sets the clock: [AUTO <RDS>], [MANUAL].
TUNING STEP (tuning step)
Sets the FM/AM tuning step of your country: [FM50K/AM9K], [FM100K/AM10K], [FM200K/AM10K].
(Available only while the source is off and the clock is displayed.)
DETACH ALERT (detach alert)
Activates the detach alert: [ON], [OFF].
The detach alert will sound for a few seconds if you turn the ignition switch to the OFF position without detaching the
front panel. The alarm will only sound if the built-in amplifier is used.
(Available only while the source is off and the clock is displayed.)
BEEP (beep)
Activates the beep sound: [ON], [OFF].
AUTO OFF (auto off)
Shuts off automatically after a certain time when the unit is turned off and the clock is displayed (i.e. press and hold OFF
for 1 second): [ENABLE] (30 minutes), [DISABLE].
SPEAKER LOAD (speaker impedance load)
Sets the impedance load of the speaker connection: [4 OHM] (4 Ω load connection), [2 OHM] (2 Ω load connection).
Be sure to set to [2 OHM] when making the speaker parallel connection for high volume playback.
(Available only while the source is off and the clock is displayed.)
USB AUTOPLAY (USB auto play)
Activates the USB auto play: [ON], [OFF].
USB MODE (USB mode)
To Next Page
Loading...
