Sony GV-D200 - Adjusting Items When Replacing Main Parts and Boards

5-2
Mechanism deck *1 Mechanism deck M901 (Drum assy) *1 Mechanism deck M902 (Capstan motor)
Mechanism deck LS chassis assy LCD block ND901 (Fluorescent tube) *2 LCD block LCD901 (LCD panel) *2 PD-130 board IC5501 (RGB driver (LCD)) *2 PD-130 board IC5502 (Timing generator (LCD)) *2
PD-130 board Q5602, T5601 (Inverter) *2 VC-250 board IC3103 (REC/PB AMP) VC-250 board IC3101 (EQ, A/D conv. PLL) VC-250 board IC3701 (LINE IN/OUT) VC-250 board IC3301 (DV signal process) VC-250 board IC1504, X1501 (X’tal OSC)
VC-250 board IC2291 (EVR) VC-250 board IC2201 (Hi8/Std8 Y/C process) VC-250 board IC3901 (IR transmitter) VC-250 board IC5701 (AUDIO IN/OUT) PD-130 board (COMPLETE) *2
VC-250 board (COMPLETE) VC-250 board IC4502 (EEPROM) VC-250 board IC4901 (EEPROM)
Replaced parts Board EEPROM
Block replacement Parts replacement replacement replacement
zz
zz
zz
zz
zz zz
zz z z
zz z z
zz z z
zz z z
zz z z
zz z z
zz z z
zzz
zz z z
zz z z
zzz
zz z z
zz z z
zzz zz
zzz z z
zzzz
zzzz
zzzz
zz
zzzz
zzzz
zz zzz
zzzz
zz z z z
zz z z z z z
zzzz
Adjustment
Section
Initialization of
C,D,E,F,7,8
page data
System control
Servo & RF
Video
IR
Audio
LCD *2
Mechanism
Adjustment
Initialization of C, D, 8 page data
Initialization of E, F, 7 page data
Serial No. input
Battery end adj.
REEL FG adj.
Switching position adj.
AGC center level adj.
APC & AEQ adj.
PLL fo & LPF fo adj.
Hi8/Std8 switching position adj.
CAP FG duty adj.
27MHz origin oscillation adj.
Chroma BPF fo adj.
S VIDEO OUT Y level adj.
S VIDEO OUT chroma level adj.
Hi8/Std8 Y/C output level setting
Hi8/Std8 AFC fo adj.
IR video carrier frequency adj.
IR video deviation adj.
IR audio deviation adj.
Hi8/Std8 AFM BPF fo adj.
Hi8/Std8 AFM 1.5MHz deviation adj.
Hi8/Std8 AFM 1.7MHz deviation adj.
LCD initial data input
VCO adj.
RGB AMP adj.
Contrast adj.
COM-AMP adj.
V-COM adj.
White balance adj.
Tape path adj.
Table. 5-1-1
1-1. Adjusting items when replacing main parts and boards.
When replacing main parts, adjust the items indicated by z in the following table.
*1: When replacing the drum assy. or mechanism deck, reset the data of page: 2, address: A2 to A4 to “00”. (Refer to “Record of Use check”
of “5-4. SERVICE MODE”)
*2: GV-D800/D800E only