35
Recording
– Basics
Self-timer recording
Recording automatically starts in 10 seconds after you set the self-timer. You can also
use the Remote Commander for this operation.
(1) In standby, press FN and select PAGE2 (p. 22).
(2) Press SELFTIMER.
The
(self-timer) indicator appears on the screen.
(3) Press START/STOP.
The self-timer starts counting down from 10 with a beep sound. In the last two
seconds of the countdown, the beep sound gets faster, then recording starts
automatically.
To stop the count down
Press START/STOP.
To restart the countdown, press START/STOP again.
To cancel self-timer recording
Press SELFTIMER so that the (self-timer) indicator disappears from the screen while
your camcorder is in standby. You cannot cancel self-timer recording using the Remote
Commander.
Note
Self-timer recording is automatically canceled when:
– Self-timer recording is finished.
– The POWER switch is set to OFF (CHARGE) or VCR.
When the POWER switch is set to MEMORY
You can also record images with the self-timer (p. 126, 138).
Recording a picture
1
FN
START/STOP
START/STOP
To Next Page
Loading...
Need help?
General