38
— Playback – Basics —
Playing back a tape
You can monitor the recorded tape etc. on the LCD screen. If you close the LCD panel,
you can monitor the playback picture in the viewfinder. You can also control playback
using the Remote Commander supplied with your camcorder.
(1) Prepare the power source and insert the recorded tape.
(2) Set the POWER switch to VCR while pressing the small green button.
(3) Press OPEN to open the LCD panel.
(4) Press
to rewind the tape.
(5) Press
to start playback.
(6) Adjust the volume following the steps below.
1 Press FN to display PAGE1.
2 Press VOL. The screen to adjust volume appears.
3 Press –/+ to adjust the volume.
– : to decrease the volume
+ : to increase the volume
(7) Press
OK to return to PAGE1.
To return to FN
Press EXIT.
To stop playback
Press .
5
4
2
6
1
3
VOL
– +
OK
FN
POWER
MEMORY
VCR
CAMERA
OFF
(CHARGE)
LOCK
The bar indicator
To Next Page
Loading...
Need help?
General